Hardware options installation 41
• DIMMs must be installed in decreasing capacity with the largest DIMMs installed in the banks
furthest from each processor.
NOTE: If all four banks on a memory node ("DIMM slot identification" on page 9) are
populated, the maximum memory clock speed is 533 MHz. If two or fewer banks on a
memory node are populated, the maximum memory clock speed is 667 MHz.
To install a DIMM:
1. Power down the server (on page 27).
2. Remove the processor memory module, and open the cover ("Removing the processor memory
module" on page 32).
3. Open the DIMM slot latches.
4. Install the DIMM.
Hard drive guidelines
To Next Page
Loading...
