Hardware options installation 46
IMPORTANT: For maximum server availability, be sure that the two power supplies are
powered by separate AC power sources.
NOTE: If the server will be shipped to another location after configuration, install a shipping
screw into each power supply.
Expansion boards
Slot Description
1 PCI-X non-hot-plug expansion slot, 64-bit/100-MHz (half-
length)
2 PCI-X non-hot-plug expansion slot, 64-bit/100-MHz (full-
length)
3 PCI Express x4 non-hot-plug expansion slot (full-length)
4 PCI Express x4 non-hot-plug expansion slot (full-length)
5 PCI Express x8 non-hot-plug expansion slot (full-length)
6 PCI Express x4 non-hot-plug expansion slot (full-length)
7 PCI Express x8 non-hot-plug expansion slot (full-length)
8 PCI Express x8 non-hot-plug expansion slot (full-length)
9 PCI Express x4 non-hot-plug expansion slot (half-length)
Installing an expansion board
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the expansion boards.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all expansion slots have either an expansion slot cover or an expansion board installed.
To Next Page
Loading...
