3. Lift the front of the board (5) up, and then pull the board (6) into the computer to remove it.
To install the I/O board, reverse this procedure.
NFC module
To remove the NFC module, use this procedure and illustration.
Table 8-6
NFC module descriptions and part numbers
Description Spare part number
NFC module
NOTE: The NFC module spare part kit does not include the antenna. The antenna is included in the
touchpad spare part kit.
914758-001
NFC module cable (included in Cable Kit) N98721-001
NFC antenna N96725-001
Before removing the NFC module, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 62).
2. Remove the bottom cover (see Bottom cover on page 62).
3. Remove the battery (see Battery on page 74).
Remove the NFC module:
1. Disconnect the system board cable from the ZIF connector (1) on the top of the NFC module.
2. Disconnect the touchpad antenna cable from the ZIF connector (2) on the bottom of the NFC
module.
80
Chapter 8 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
