To install the smart card reader, reverse this procedure.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 8-8 Touchpad descriptions and part numbers
Description Spare part number
Touchpad for use in models without NFC N96237-001
Touchpad for use in models with NFC N96237-001
Touchpad cable (included in Cable Kit) N98721-001
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 62).
2. Remove the bottom cover (see Bottom cover on page 62).
3. Remove the battery (see Battery on page 74).
Remove the touchpad:
1. Move the speaker cable (1) from the touchpad.
NOTE: If you have to remove tape from the cable, be careful to leave the cable intact.
2. Disconnect the system board cable from the ZIF connector (2) on the touchpad.
3. Disconnect the cable from the ZIF connector (3) on the NFC module.
4. Remove the four Phillips M2.0× 2.0 screws (4) that secure the touchpad to the computer.
5. Remove the three Phillips M1.6 × 2.0 screws (5) that secure the touchpad to the computer.
6. Remove the touchpad (6) from the computer.
To install the touchpad, reverse this procedure.
Touchpad
83
To Next Page
Loading...
