Before removing the smart card reader, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 62).
2. Remove the bottom cover (see Bottom cover on page 62).
3. Remove the battery (see Battery on page 74).
4. Remove the left speaker (see Speakers on page 76).
Remove the smart card reader:
1. Remove the four Phillips M2.0 × 2.5 screws (1) from the smart card reader bracket.
2. Remove the bracket (2).
3. Lift the tape (1) off the connector on the smart card reader.
4. Disconnect the cable from the ZIF connector (2) on the smart card reader.
5. Remove the smart card reader (3) from the computer.
82
Chapter 8 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
