3. Use a tool to release the module (3), and then remove the module from the computer (4). The module is
secured with adhesive.
Reverse this procedure to install the NFC module.
Fan
To remove the fan, use this procedure and illustration.
Table 6-10 Fan description and part number
Description Spare part number
Fan assembly M44335-001
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 32).
2. Remove the bottom cover (see Bottom cover on page 32).
3. Disconnect the battery cable from the system board (see Battery on page 42).
Remove the fan assembly:
1. Disconnect the fan cable from the system board (1).
2. Remove the cables from the clips on the side of the fan (2).
52 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
