3. Disconnect the battery cable from the system board (see Battery on page 43).
4. Remove the power connector cable (Power connector cable on page 48).
Remove the display assembly:
1. Disconnect the display cable (1) and remove it from the clip (2).
2. Disconnect the antenna cables from the WWAN module (3), and then remove the cables from the clip
(4).
3. Disconnect the antenna cables from the WLAN module (5) and disconnect the left display cable (6), and
then remove the cables from the clips along the side of the fan
(7).
4. Remove the six Phillips M2.5 × 4.0 screws (1) that secure the display assembly to the computer.
5. Rotate the display to open the hinges (2).
60 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
