8. If you need to remove the hinge cover from the display enclosure:
a. Remove the Phillips M1.6 × 3.0 screw (1) that secures the hinge cover to the display.
b. Slide the hinge cover toward the right (2).
c. Rotate the bottom of the hinge cover up, and then remove it from the display (3).
d. Note the location of all cables hidden by the hinge cover so that you can be sure to properly route
the cables during reassembly.
The hinge cover is available in the Hinge Kit as spare part number M07104-001.
9. If you need to remove the hinges from the display enclosure:
a. Remove the three Phillips M2.0 × 10.0 screws (1) from each hinge.
b. Remove the hinges from the display (2).
62 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
