16. If you need to remove the microphone board from the display, disconnect the cable from the reverse ZIF
connector on the board (1), and then use a tool (2) to release the board from the computer (3).
The microphone board is available as spare part number M07208-001 and M07209-001 for the rear-
facing third microphone.
17. If you need to remove the camera module:
▲ Use a tool (1) to lift up evenly across the module and peel the module up from the display back
cover (2), and then disconnect the cable from the reverse ZIF connector on the module (3). The
camera module is available as spare part number M07216-001 for RGB cameras and M08549-001
for IR cameras.
NOTE: For installation, note that the cable routes under the camera module before it connects to
the module.
Component replacement procedures 67
To Next Page
Loading...
