Front bezel dust lter
Some models are equipped with an optional front bezel dust lter. You must periodically clean the dust lter
so that the dust collected on the lter does not impede air ow through the computer.
NOTE: The optional front bezel dust lter is available from HP.
To remove, clean, and replace the dust lter:
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. To remove the dust lter, use your ngers to separate the lter from the front bezel at the tab locations
shown below.
3. Use a soft brush or cloth to clean dust from the lter. If heavily soiled, rinse the lter clean with water.
4. To replace the dust lter, press the lter rmly onto the front bezel at the tab locations shown below.
Front bezel dust lter 23
To Next Page
Loading...
