5. Press the Connect button on the receiver for approximately ve seconds. The status light on the receiver
will ash for approximately 30 seconds after the Connect button is pressed.
6. While the status light on the receiver is ashing, press the Connect button on the underside of the
mouse for ve to ten seconds. After the Connect button is released, the status light on the receiver will
stop ashing, indicating that the devices have been synchronized.
NOTE: If the mouse and keyboard still do not work, remove and replace the batteries. If the mouse and
keyboard are still not synchronized, synchronize the keyboard and mouse again.
46 Chapter 3 Hardware upgrades
To Next Page
Loading...
