9. Slide the optical drive through the front bezel all the way into the bay (1) so that the latch on the rear of
the drive locks into place (2).
10. Connect the power cable (1) and data cable (2) to the rear of the drive.
11. Connect the opposite end of the data cable to one of the light blue SATA connectors on the system board
labeled SATA1 or SATA3.
NOTE: Refer to System board connections on page 13 for an illustration of the system board drive
connectors.
12. Replace the front bezel if it was removed.
13. Replace the computer access panel.
14. If the computer was on a stand, replace the stand.
15. Reconnect the power cord and any external devices, and then turn on the computer.
16. Lock any security devices that were disengaged when the access panel was removed.
Removing and installing drives 25
To Next Page
Loading...
