Connecting the Monitor Cables
1. Place the monitor in a convenient, well-ventilated location near the computer.
2. Remove the cable management clip from the pedestal by pulling outward on the two sides of the
clip (1) then lifting the clip off the pedestal (2).
3. Connect one end of an Ethernet cable to the RJ-45 (network) jack on the monitor and the other
end to an RJ-45 wall jack or router.
4. Connect peripheral USB devices to the USB ports on the monitor as needed. USB ports are
located on the rear panel.
ENWW Connecting the Monitor Cables 5
To Next Page
Loading...
