a. NFC antenna (see NFC antenna on page 35)
b. WWAN module (see WWAN module on page 36)
c. Power button board (see Power button board on page 42)
d. Battery (see Battery on page 48)
e. System board (see System board on page 50)
Remove the WLAN antenna:
1. Release the WLAN antenna cables from the routing channel (1) built into the bottom cover.
2. Detach the WLAN antenna transceivers (2) from the bottom cover.
3. Release the tabs (3) built into the bottom cover that secure the speaker cable, and then release the
WLAN antenna cables.
4. Remove the WLAN antenna cables and transceivers (4).
Reverse this procedure to install the WLAN antenna.
Tablet component replacement procedures 59
To Next Page
Loading...
