3. Release the ZIF connector (3) to which the right-side credit card reader board cable is attached, and
then disconnect the right-side credit card reader board cable (4) from the left-side credit card reader
board.
4. Remove the left-side credit card reader board.
5. Detach the right-side credit card reader board cable (1) from the rear cover. (The right-side credit card
reader board cable is attached to the rear cover with double-sided adhesive.)
6. Remove the Phillips PM1.9×3.0 screw (2) that secures the right-side credit card reader board to the rear
cover.
Retail Jacket component replacement procedures 75
To Next Page
Loading...
