2.4 Active/inactive support for P6000 management and replication software
Software
Active As Of Inactive As Of
9.2 31 Dec 2011
9.2.1 31 Dec 2011
9.3 30 Mar 2012
9.4 6 June 2011
10.0
1
14 Oct 2011
3.0 30 Nov 2009
3.1 30 Nov 2009
4.0 30 Nov 2009
4.0.1 16 Feb 2010
5.0 6 June 2011
5.1 31 Dec 2011
5.2 30 Mar 2012
5.3 6 June 2011
5.4 14 Oct 2011
2.0 30 Nov 2009
2.1 30 Nov 2009
3.0.1 6 June 2011
3.1 6 June 2011
3.2 31 Dec 2011
3.3 30 Mar 2012
3.4 6 June 2011
4.0
HP P6000 SmartStart
HP P6000 Replication Solutions Manager
HP P6000 Command View
This table identifies which versions of P6000 management and replication software are active and inactive. Because the active/inactive designations became effective in November
2009, there are multiple versions that list the same inactive date. Active and inactive are defined as:
– Active: An active version has full Engineering support. Issues are addressed and patches can be provided.
– Inactive: An inactive version has limited Engineering support. Customers will be requested to move to an active version. Engineering is available for consultation but lab resources
are not available to address issues. The escalation path for an issue on an inactive version is limited. The oldest active software version goes inactive approximately six months after a
new version is released. For example, if the current active versions are 9.3, 9.4, and 10.0, 9.3 goes inactive six months after 10.0 is released.
NOTE: When a version of HP P6000 Command View goes inactive, the same version of HP Command View EVAPerf, HP Storage System Scripting Utility, and HP SMI-S EVA also
goes inactive.
To Next Page
Loading...
Need help?
General
