HP EVA P6000

FROM HP P6000
Command View
version
9.2 9.2.1 9.3 9.4 10.0
9.1
•
9.2
• • • •
9.2.1
1
• • •
9.3
• •
9.4
•
TO HP P6000 Command View version
This table shows upgrade support for HP P6000 Command View versions. A
bullet (•) indicates you can perform an upgrade from the version in the
FROM column to the version in the TO column without removing the earlier
version. A blank cell (or if an HP P6000 Command View version is not
listed) indicates an upgrade to a later version (without removing the earlier
version) is not supported. For unsupported upgrade paths, you must remove
the previous version using Windows Add/Remove Programs, reboot the
management server, and install the applicable version listed below.
NOTE: For supported upgrade paths, it is possible that a reboot occurs
1
You must have 9.2 installed before you can upgrade to 9.2.1.
2.1 HP P6000 Command View upgrade support
8