1. Remove the four Phillips M2.5 × 3.5 screws that secure the display assembly to the computer.
2. Lift the tape (1) that covers the display connector on the system board. You do not have to
completely remove the tape.
3. Disconnect the display cable (2) from the ZIF connector on the system board.
4. Remove the Phillips M2.0 × 3.0 screw (3) that secures from the bracket on the WWAN module, and
then remove the bracket (4).
5. Disconnect the antenna cables (5) from the WWAN module.
Display assembly
45
To Next Page
Loading...
