.
-n
, the uncertainty of an
approximation changes by about a factor of 10 for each digit specified in the
display format. This will generally not be exact in i or ^ display
format, however, because changing the number of digits specified may
require that the function be evaluated at different sample points, so that
(x) ~ 10
m(x)
would have different values.
Note that when an integral is approximated in • display format, m(x) =
0 and so the calculated uncertainty in the approximation turns out to be
×10
-n
(b a).
Normally you do not have to determine precisely the uncertainty in the
function. (To do so would frequently require a very complicated analysis.)
Generally, it's more convenient to use i or ^ display format if the
uncertainty in the function's values can be more easily estimated as a
relative •
display format if the uncertainty ues can be more easily
estimated as an absolute uncertainly. • display format may be
inappropriate to use (leading to peculiar results) when you are integrating a
function whose magnitude and uncertainty have extremely small values
within the interval of integration. Likewise, i display format may be
inappropriate to use (also leading to peculiar results) if the magnitude of the
function becomes much smaller than its uncertainty. If the results of
calculating an integral seem strange, It may be more appropriate to calculate
the integral in the alternate display format.
To Next Page
Loading...
Need help?
General
