The m and W (memory status) functions are described in detail in
appendix C.
Keep in mind that an error message will result (given the above memory
configuration) if
You try to address a register higher than R
19
(R
.9
), which initially is
the highest register allocated to data storage (Error 3).
Program Boundaries
End. Not every program needs to end with a n or ¦ instruction. If
you are at the end of occupied program memory, there is an automatic
n instruction, so you do not need to enter one. This can save you one
transferring execution to another routine using t (section 7).
Labels. Labels in a program (or subroutine) are markers telling the
calculator where to begin execution. Following an ´ label or G label
instruction, the calculator will search downward in program memory for the
*
For memory allocation and indirect addressing, registers R
.0
through R
.9
are referred to as R
10
through R
19
.
To Next Page
Loading...
Need help?
General
