1Stop bits:
115.2KbpsSpeed:
3. Log in as user admin with the password admin.
Note: You can only log into the active controller. If you cannot log in, move the laptop computer or workstation
connection to the other controller and try to log in again.
After you have logged in, the CLI is ready to accept commands.
What to do next
Type ? to see a list of commands.
Type the command followed by --help to see the usage information for that command.
Complete the Initial Setup Using the CLI
Before you begin
Before you start, fill out the Installation Checklist on page 18. You need the information from the checklist to perform the
initial CLI setup.
Note: Subnet and VLAN configuration is a separate action.
Procedure
1. After you are logged into the active controller, type:
setup
The Terms and Conditions are displayed.
2. Click Enter to read the Terms and Conditions, then type yes to accept them.
3. Type the following information as requested. Example values are shown here.
Important: Use your own values for each item in the following sample. If you accept an incorrect entry, you must
start the setup process again.
• Array name: greyhound
• Group name: storehouse
• Management IP address: 10.12.128.79
• Management netmask: 255.255.0.0
• Default gateway IP address: 10.12.255.254
• Domain name: admin.storage.com
• New password:
4. Specify whether to include IPs in the group certificates: yes or no.
• Type yes to include the array's IP address in the certificate. When using this option, you will have to create a new
certificate if the array's IP address changes.
• Type no to exclude the array's IP address from the certificate..
5. Specify whether you want to continue the setup in the GUI.
• Type yes to open the GUI. Then complete Initial Setup Using the Storage Setup Manager for Windows on page 38.
• Ttype no to continue with the CLI. Then complete the remaining steps in this procedure.
6. Type the following information as requested. Example values are shown here.
Install the HPE Storage Array 44
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
To Next Page
Loading...
Need help?
General