HPE Synergy 12000 Frame
-48V DC Power Supply
Installation Instructions
©
Copyright 2017, 2019 Hewlett Packard Enterprise Development LP
*873191-002*
Part Number: 873191-002
Published: September 2019
Edition: 2
Overview
This document provides instructions for installing an HPE
Synergy 12000 Frame -48V DC Power Supply.
For more information on frame components and procedures
related to option installation, see the HPE Synergy 12000 Frame
Setup and Installation Guide on the Hewlett Packard Enterprise
website (http://www.hpe.com/info/synergy-docs).
Kit contents
• Power supply
• Two (2) compression two-hole lugs
• Four (4) input terminal screws
• This document
Mobile documentation
Warnings and cautions
WARNING: To reduce the risk of personal injury from hot
surfaces, allow the power supply or power supply blank to
cool before touching it.
WARNING: To reduce the risk of electric shock or damage
to the equipment, do not connect the power cord to the
power supply until the power supply is installed.
CAUTION: To prevent improper cooling and thermal
damage, do not operate the frame unless all bays are
populated with either a component or a blank.
WARNING: To reduce the risk of electric shock, be sure
that the cable grounding kit is properly installed and
connected to a suitable protective earth terminal before
connecting the power source to the frame .
Page 1
To Next Page
Need help?
General
