HP Integrity BL860c Quick Start

1
Console Quick Start
HP Integrity BL c-Class Servers
Usethisconsolequickstart foranHPIntegrityBLc‐Classserverbladein stalledintheenclosure,set
up,andreadytoconnecttoahostconsole.

Thisconsolequickstartonlyprovidesbasicsteps.Fordetailedinformation,seetheHPIntegrity
InstallationGuideforyourserverbladeorthe
HPIntegrityIntegratedLights‐Out2OperationsGuide.

Toconnecttoahostconsole,useoneofthefollowingmethods:
 AccessingiLO2WithDHCPEnabled.UsetheOnboardAdministratoriLO(OA/iLO)
networkportontherearoftheenclosure.IftheOA/iLOnetworkportontheenclosureis
connectedtoalocalnetworkthathasa DHCPserver,youriLO2MPIPaddressis
automaticallygeneratedbythe
DHCPserver.TheserverbladeisfactorysetwithDHCP
enabled.
 AccessingiLO2WithNoNetworkConnection.UsetheRS‐232portontheSUVcable.If
theenclosureisnotconnectedtoanynetwork,youmustconfiguretheserverbladethrough
theRS‐232serialconsoleportontheSUVcable.
AccessingiLO2WithDHCPEnabled
1. ConnectaLANcabletotheiLO/OAnetworkportontherearoftheenclosure.The
followinggraphicshowsbothavailableenclosuresfortheBLc‐Classserverblades.
c7000Enclosure c3000Enclosure

2. ConnecttheLANcabletoalocalnetworkthathasaDHCPserver.
3. SelectBladeorPortInfoontheLCDdisplaypanelonthefrontoftheenclosure.
4. SelectBladeInfo,selecttheappropriateserverblade,andwritedowntheiLO2MPIP
address.

HP Integrity BL860c Specifications

General

Form Factor	Blade
Processor	Intel Itanium 2
Number of Processors	2
Memory	Up to 128 GB
Memory Slots	16
Processor Speed	1.6 GHz
Memory Type	DDR2 SDRAM
Hard Drive Form Factor	SFF
Operating Systems	HP-UX, Linux, Windows Server
Power Supply	Redundant, hot-swappable power supplies