HP Integrity NonStop NB54000c Introduction

13
Setting a power cap for a group of servers
Insight Control is the sole tool for setting power caps for groups of ProLiant ML and DL servers. Using the Insight
Control interface (Figure 7), an administrator can apply a group power cap that is between the minimum power
and the power supply rating of the entire group.
Figure 7. Setting a group power cap in Insight Control
Setting a BladeSystem enclosure power cap
You can use either the OA or Insight Control to set the power cap for a BladeSystem enclosure to any value
between the power cap lower bound and the maximum available power for the enclosure. Figure 8 shows the
Power Management screen from HP Onboard Administrator. This screen is where you set the Enclosure Dynamic
Power Cap.

HP Integrity NonStop NB54000c Specifications

General

Brand	HP
Model	Integrity NonStop NB54000c
Category	Server
Language	English