Product Information
For detailed information about this product, see http://www.hp.com/go/integrity_servers-docs.
Regulatory Information
For your protection, this product has been tested for conformance to various national and
international regulations and standards. The scope of this regulatory testing includes electrical
and mechanical safety, electromagnetic emissions, immunity, acoustics and hazardous materials.
When required, approvals are obtained from third party test agencies. Approval marks appear
on the product label. In addition, various regulatory bodies require some information under the
headings listed in this section.
Regulatory Model Number
For the purpose of regulatory compliance certifications and identification, this product is assigned
an HP regulatory model number. The HP regulatory model number for this product is
RSVLA-RC01. This number can be found on the product label, along with the required approval
markings and information. When requesting certification information for this product, always
refer to this regulatory model number.
NOTE: Do not confuse the regulatory model number with the marketing or model number.
Electrical Safety
This product has not been evaluated for connection to an “IT” power system (AC distribution
system having no direct connection to earth according to IEC 60950).
Installation Conditions
See installation instructions before connecting this equipment to the input supply.
WARNING! The equipment must be provided with a proper AC protective earth (PE) ground
connection.
Network Connected Equipment
WARNING! The installation must provide a ground connection for the network equipment.
Electrostatic Discharge (ESD) Precautions
When handling any electronic component or assembly (such as a PCI card or memory DIMM),
you must observe the following antistatic precautions to prevent damage. An ESD kit is available
(or supplied with memory additions). This kit contains one wrist strap, one conductive sheet,
and one antistatic foam pad.
• Always disconnect power from the server and wear a grounded wrist strap when working
around the server. Always wear a grounded wrist strap when handling printed circuit
boards.
• Treat all assemblies, components and interface connections as static-sensitive.
• Avoid working in carpeted areas, and keep body movement to a minimum while removing
or installing boards, to minimize buildup of static charge.
4 HP Integrity rx2800 i2 Safety and Regulatory Information
To Next Page
Loading...
Need help?
General