HPE Integrity Superdome X
HPE Superdome X products are comprised of two main components: HPE BladeSystem Superdome Enclosure and the BL920s
The system can be field racked. However, it is strongly recommended that customers order the systems
racked from the factory. This provides the customer the benefit of extensive system testing and avoids
possible premium service charges for field racking service. An important restriction to note about field racked
units: field racked units are limited to single blade configurations due to weight limitations. Additional blades
must be ordered as separate items and will be shipped along with the enclosure. Field racking requires the
use of an appropriate material lift capable of lifting 400 lbs. The RONI lift is no longer available for purchase.
Suggested replacement is the Genie Material Lift GL-8 (
http://www.genielift.com/).
Overall
L x W
Base
Dimensions
Width ā
stowed
Capacity Weight
GL-8
Standard
Base GL-8
10 ft. 5 in 2 ft. 0.75 in 400 lbs 132 lbs.
HPE Superdome X systems are supported in the HPE 600 mm wide 42U Intelligent Series rack.
Other products may be placed in the same rack as Superdome X. Placement of these other products must not
result in moving the server enclosure.
All racks in the same order must be the same height and width.
HPE Superdome X Hardware Configuration
Superdome Enclosure (AT147B/AT147A)
Number of BL920s Blades (min/max) per compute enclosure
Number of CAMnet Completer modules (CCMs)
Number of processor per compute enclosure (min/max)
(increments of 2)
Number of DIMMs
(increments of 16 DIMMs per Blade)
Number of Crossbar Fabric Modules (XFMs)
1 Type A Mezzanine slot per Blade
2 Type B Mezzanine slots per Blade
Number of GPSMs (Global Partition Services Modules)
NOTE: The SUV dongle cable is HPE part number 409496. It connects to the SUV port on the front of each blade and brings out
To Next Page
Loading...
