3
Configuring the Computer
System configuration is the process of specifying the devices and
programs that make up a computer system. When you add or
remove accessories, the computer must be reconfigured to
recognize these changes.
The information in this chapter is only applicable if you
installed an additional (second) drive. If you just
upgraded your existing hard drive and transferred your
data from an old drive to the new drive, you may skip
the procedures on drive partitioning unless you
encounter problems upon start up.
If you are installing a SATA drive in your computer for
the first time, you must refer to the white paper
“Implementation of Serial ATA on HP Business Desktops”
for operating system instructions. The white paper is
located at http://www.hp.com/support.
345524-B21.book 1 ページ ２００３年８月２２日 金曜日 午後４時６分
To Next Page
Loading...
Need help?
General