Configuring the Computer
SATA Hard Drive Installation Guide 3–3
6. Click Disk Management. This starts the Write Signature and
Upgrade Disk Wizard. Click Cancel to stop the wizard.
7. Right-click the Disk 1 Unallocated area.
8. Select Create Partition and run the wizard.
9. Click Next.
10. Select the partition needed or use the defaults.
11. Click Next.
12. Specify the partition size or use the defaults.
13. Click Next.
14. Specify the drive letter of the partition or use the default.
15. Click Next.
16. Select Choose Partition File System and other Partition
Parameters or use the defaults.
You will be prompted by the system to upgrade to a
Dynamic drive. Refer to www.microsoft.com/support for
more information or refer to the Microsoft OS Manual
that shipped with your computer. Otherwise, select the
default to continue.
345524-B21.book 3 ページ ２００３年８月２２日 金曜日 午後４時６分
To Next Page
Loading...
Need help?
General
