HP iPAQ hx2000 Series - Page 82

8VHU·V*XLGH ²
8VLQJ6HFXULW\)HDWXUHV
Setting “Password OR fingerprint” for Logon
In this mode, you are required to enter an alphanumeric password
with at least seven characters or a fingerprint to logon.
✎
The alphanumeric password must contain a combination of upper
and lower case letters, numbers, and punctuation.
1. From the Today screen, tap Start > Settings > Password.
2. Select “Password OR fingerprint” from the down arrow list.
3. Select from the down arrow list the length of time the
iPAQ Pocket PC can remain unused before you must reenter
the password.
4. Enter seven alphanumeric characters in the Password field.
5. Repeat step 4 in the Confirm field.
6. Tap OK.
7. Tap a finger to enroll.
8. Swipe the selected finger, as instructed.
✎
For more information on finger swiping, see the section
“Enrolling a Fingerprint” or tap the Training button.
9. Tap OK.
10. Tap Yes to save changes.
Setting “Password AND Fingerprint” for Logon
In this mode, you are required to enter both a password with at
least seven characters and a fingerprint to logon.
✎
The alphanumeric password must contain a combination of upper
and lower case letters, numbers, and punctuation.