HP Irvine - Page 17

13
Audio Connector : F_AUDIO1
The connector is for a chassis-mounted front
panel I/O module that supports High Dinition
Audio standard (HD Audio). Connect one end
of the front panel audio I/O module cable to this
connector.
USB Connectors : F_USB1/2/3
In addition to the four USB ports on the rear
panel, this product also provides three 10-pin
USB headers on its motherboard. By connecting
through USB cables with them, user can quickly
build another six USB ports on the front panel
.Serial ATA II Connectors : SATA_1/2
The Serial ATA II connector is used to connect
with relevant Hard Disk or CD devices which
supporting this feature. The current Serial ATA
II interface allows up to 300MB/s data transfer
rate.
Fan Connectors : CPU_FAN
The CPU fan speed can be detected and viewed
in the BIOS Setup. The fan will be automatically
turned off after the system enters S3, S4 and S5
modes.
PORT1_L
PORT1_R
PORT2_L
PORT2_R
SENSE_SEND
S E N S E 1 _ R E T U R N
PR ES E NC E_ J
EMPTY
S E N S E 2 _ R E T U R N
AUD_GND
1 2
10
9
F_AUDIO1
SATA_2
RX-
GND
GND
TX-
TX+
GND
RX+
1
SATA_1
RX-
GND
GND
TX-
TX+
GND
RX+
1
1
CONTROLPOWER
GND SENSE
CPU_FAN
NC
GND
D+
D-
D+
GND
D-
VCC
EMPTY
1 2
109
F_USB 1/2/3
VCC