2-9
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
• Subnet Mask – This mask identifies the host address bits used for
routing to specific subnets. (Default: 255.255.255.0)
• Gateway IP Address – IP address of the gateway router between
this device and management stations that exist on other network
segments. (Default: 0.0.0.0)
• Management VLAN – ID of the configured VLAN (1-4093, no leading
zeroes). By default, all ports on the switch are members of VLAN 1.
However, the management station can be attached to a port belonging
to any VLAN, as long as that VLAN has been assigned an IP address.
Note Be sure to keep a record of the switch’s IP address. If you cannot remember
the switch’s IP address, you can restore the original settings by following the
procedure described in the “Troubleshooting” section.
If you change the switch IP address, you must close the Web interface and
start a new session using the new IP address.
Web – Click System, IP Address. Enter the IP address, subnet mask, gateway,
and select the Management VLAN, then click APPLY.
To Next Page
Loading...
