<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] undo oam enable
[Sysname-Ethernet1/0/1] oam mode passive
oam timer hello
Syntax
oam timer hello interval
undo oam timer hello
View
System view
Default level
2: System level
Parameters
interval: Ethernet OAM handshake packet transmission interval, in milliseconds. The value of this
argument must be a multiple of 100, it ranges from 500 to 5000.
Description
Use the oam timer hello command to configure the Ethernet OAM handshake packet transmission
interval.
Use the undo oam timer hello command to restore the default.
By default, the Ethernet OAM handshake packet transmission interval is 1000 milliseconds.
After the timeout timer for an Ethernet OAM connection expires, the local OAM entity ages out its
connection with the peer OAM entity, causing the OAM connection to be disconnected. HP recommends
that you set the connection timeout timer at least five times the handshake packet transmission interval,
ensuring the stability of Ethernet OAM connections.
Related commands: oam timer keepalive and display oam configuration.
Examples
# Set the Ethernet OAM handshake packet transmission interval to 500 milliseconds—assume that the
Ethernet OAM connection timeout timer is 2500 milliseconds.
<Sysname> system-view
[Sysname] oam timer hello 500
oam timer keepalive
Syntax
oam timer keepalive interval
undo oam timer keepalive
View
System view
Default level
2: System level
18
To Next Page
Loading...
Need help?
General
