Use the undo dldp work-mode command to restore the default DLDP mode.
By default, a switch operates in normal DLDP mode.
Examples
# Configure the switch to operate in enhanced DLDP mode.
<Sysname> system-view
[Sysname] dldp work-mode enhance
reset dldp statistics
Syntax
reset dldp statistics [ interface-type interface-number ]
View
User view
Default level
1: Monitor level
Parameters
interface-type interface-number: Port type and port number.
Description
Use the reset dldp statistics command to clear the statistics on DLDP packets passing through a port.
If you do not provide the interface-type interface-number argument, this command clears the statistics on
the DLDP packets passing through all the DLDP-enabled ports.
Examples
# Clear the statistics on the DLDP packets passing through all the DLDP-enabled ports.
<Sysname> reset dldp statistics
28
To Next Page
Loading...
