HP Jetdirect J7949e - Page 129

ENWW Using the Embedded Web Server 129
Enable Device
Discovery
Enable or disable device discovery protocols supported by
the print server:
SLP (Service Location Protocol).
If enabled (checked), the HP Jetdirect print server
sends SLP packets, which are used by system
applications for automated discovery and installation.
If disabled (cleared), SLP packets are not sent.
mDNS (multicast Domain Name System).
If enabled (checked), Multicast Domain Name System
(mDNS) services are provided. mDNS is typically used
on small networks for IP address and name resolution
(through UDP port 5353) where a conventional DNS
server is not used.
Multicast IPv4.
If enabled (checked), the print server will send and
receive IP version 4 multicast packets.
Enable Management
Protocols
Enable or disable Telnet access and the use of FTP to
upgrade firmware on the print server. Telnet and FTP are
not secure protocols and device passwords may be
intercepted.
Enable or disable RCFG, a remote IPX configuration
protocol used by older management tools to configure
Novell NetWare parameters. Disabling RCFG does not
affect direct mode printing using IPX/SPX.
Disabling Telnet, FTP firmware upgrades, and RCFG is
recommended.
Table 4.9 Other Protocols (2 of 2)
Item Description