ENWW 6
1
Introducing the HP Jetdirect
Embedded Print Server
Introduction
This printer or multifunction peripheral (MFP) device contains an
HP Jetdirect embedded print server that is integrated directly on
the device. Using this print server, you can connect this device
directly to a network and share it among multiple users or systems.
Because the print server is built into the device, an input/output
(I/O) slot or external port is not needed for network connectivity and
may be used for other purposes.
Network Connection
Using the embedded print server and built-in RJ-45 connector, the
printer or MFP device can connect to an IEEE 802.3 10/100Base-TX
(Ethernet/Fast Ethernet) network through unshielded twisted-pair
network cables.
Autonegotiation (10/100Base-TX) is used to automatically configure
link operation at 10 Mbps or 100 Mbps, and full- or half-duplex
communication mode, as required by the network. However, link
operation may be manually set using several configuration tools,
such as the printer control panel (if supported), Telnet and TFTP
commands, a Web browser, and network management software.
These tools are described later in this guide.
Note Unless otherwise specified, the term print server in
this manual refers to an HP Jetdirect print server
and not a separate computer running print server
software.
To Next Page
Loading...
Need help?
General
