HP Jetdirect J7949e - FTP Login

ENWW FTP Printing 155
FTP Login
To start an FTP session, enter the following command from a
MS-DOS or UNIX command prompt:
ftp <IP address>
where <IP address> is the valid IP address or node name
configured for the HP Jetdirect print server. See Figure 6.1
Figure 6.1 FTP Login Example
If the connection is successful, a Ready message will be displayed.
After a successful connection, the user is prompted for a login name
and password. The default is the client’s login name. The Jetdirect
FTP server will allow any user name. Passwords are ignored.
If login is successful, a message “230” will be displayed on the client
system. In addition, the available HP Jetdirect ports for printing
will be displayed. HP Jetdirect print servers supported in this guide
provide a single port (Port 1). For a typical FTP printing session,
see “Example of an FTP Session
.”