HP Jetdirect J7949e - Page 48

ENWW TCP/IP Configuration 48
lpd-printing:
(lpd-config:, lpd:)
Enables or disables LPD (Line Printer Daemon) printing services on the Jetdirect
print server. 0 disables, 1 (default) enables.
banner:
A port-specific parameter that specifies printing an LPD banner page. 0 disables
banner pages. 1 (default) enables banner pages.
interlock:
(interlock-mode:)
Specifies whether an acknowledgement (ACK) on all TCP packets is required
before the printer is allowed to close a Port 9100 print connection. A Port Number
and Option value are specified. For HP Jetdirect embedded print servers, the Port
Number is 1. Option value 0 (default) disables interlock, 1 enables. For example,
“interlock 1 1” specifies Port 1, interlock enabled.
buffer-packing:
(packing:)
Enables or disables buffer packing for TCP/IP packets.
0 (default): is normal, the data buffer is packed before sending to the printer.
1: disables buffer packing, data is sent to the printer as it is received.
write-mode:
Controls the setting of the TCP PSH flag for device-to-client data transfers.
0 (default): disables this option, flag is not set.
1: all-push option. The push bit is set in all data packets.
2: eoi-push option. The push bit is set only for data packets that have an
End-of-Information flag set.
mult-tcp-conn:
Enables or disables multiple TCP connections.
0 (default): allows multiple connections.
1: disables multiple connections.
TCP/IP Raw Print Ports
raw-port:
(addrawport:)
Specifies additional ports for printing to TCP port 9100. Valid ports are 3000 to
9000, which are application-dependent.
Table 3.3 TFTP Configuration File Parameters (3 of 10)