ENWW TCP/IP Configuration 72
Command Line Interface (Default)
Using the Telnet command line interface, you can set configuration
parameters using the following procedures:
Note During a Telnet session, enter ? to view available
configuration parameters, the correct command
format, and a list of commands.
To list additional (or advanced) commands, enter
the command advanced befored entering ?.
To display current configuration information,
enter /.
1. At the Telnet prompt ā>ā type:
<parameter>: <value>
then press Enter, where <parameter> refers to the
configuration parameter you are defining, and <value> refers
to the definitions you are assigning to that parameter. Each
parameter entry is followed by a carriage return.
See Table 3.4
for configuration parameters .
2. Repeat the previous step to set any additional configuration
parameters.
3. When you have finished typing the configuration parameters,
type exit or quit (depending on your system).
When prompted whether to save settings that you have
changed, enter Y (default) for Yes, or N for No.
If you enter save instead of exit or quit, you will not be
prompted to save settings.
To Next Page
Loading...
