ENWW TCP/IP Configuration 74
sys-location Alpha-numeric string (up to 255 characters), typically used
to identify a location.
sys-contact Alpha-numeric string (up to 255 characters), typically used
to identify the name of a network or device administrator.
ssl-state Sets the print server’s security level for Web
communications:
1: Forced redirection to the HTTPS port. Only HTTPS
(secure HTTP) communications can be used.
2: Disable forced redirection to HTTPS. Both HTTP and
HTTPS communications can be used.
security-reset Reset security settings on the print server to factory default
values. 0 (default) does not reset, 1 resets the security
settings.
TCP/IP Main
Command Description
host-name Alphanumeric string (up to 32 characters), to assign or
change the name of the network device. For example,
“host-name printer1” assigns the name “printer1” to the
device. The default host name is NPIxxxxxx, where xxxxxx
are the last six digits of the LAN hardware (MAC) address.
ip-config Specify the configuration method:
manual: The print server will wait for IP parameters using
manual tools (such as Telnet, embedded Web server,
control panel, installation/management software). Status
will be User Specified.
bootp: The print server will send BOOTP requests on the
network for dynamic IP configuration.
dhcp: The print server will send DHCP requests on the
network for dynamic IP configuration.
auto_ip: The print server will be automatically configured
with a unique link-local address 169.254.x.x.
ip IP address for the print server, in dotted notation. For
example:
ip-config manual
ip 192.168.45.39
where ip-config specifies manual configuration and ip
manually sets the IP address 192.168.45.39 on the print
server.
Specifying 0.0.0.0 clears the IP address.
If you exit and save a new IP address, it must be specified
on the next Telnet connection.
Table 3.4 Telnet Commands and Parameters (2 of 13)
To Next Page
Loading...
Need help?
General
