ENWW TCP/IP Configuration 80
tcp-mss Specifies the maximum segment size (MSS) that the
HP Jetdirect print server will advertise for use when
communicating with local subnets (Ethernet MSS=1460
bytes or more) or remote subnets (MSS=536 bytes):
0: (default) All networks are assumed to be local (Ethernet
MSS=1460 bytes or more).
1: Use MSS=1460 bytes (or more) for subnets, and
MSS=536 bytes for remote networks.
2: All networks are assumed to be remote (MSS=536 bytes),
except the local subnet.
MSS affects performance by helping to prevent IP
Fragmentation that may result in data retransmission.
tcp-msl Specifies the maximum segment life (MSL) in seconds. The
range is 5 - 120 seconds. The default is 15 seconds.
gw-disable Specifies whether or not to automatically assign the device
IP address as the gateway when a network gateway is not
configured.
0: A gateway using the device IP address will be assigned.
1: A gateway is not assigned. The gateway address 0.0.0.0
will be configured.
default-ip Specifies the IP address to use when the print server is
unable to obtain an IP address from the network during a
forced TCP/IP reconfiguration (for example, when powered
off/on or manually configured to use BOOTP/DHCP).
DEFAULT_IP: sets the legacy default IP address
192.0.0.192.
AUTO_IP: sets a link-local IP address 169.254.x.x.
The initial setting is determined by the IP address obtained
when first powered on.
default-ip-dhcp Specifies whether DHCP requests will be periodically
transmitted when a legacy default IP address 192.0.0.192
or link-local IP address 169.254.x.x has been automatically
assigned.
0: Disables DHCP requests.
1 (default): Enables DHCP requests.
Table 3.4 Telnet Commands and Parameters (8 of 13)
To Next Page
Loading...
