HP Jetdirect J7949e - Page 84

ENWW TCP/IP Configuration 84
AppleTalk
Command Description
appletalk Enables or disables AppleTalk (EtherTalk) protocol
operation on the print server. 0 disables, 1 (default) enables.
For example,
appletalk 0 will disable AppleTalk operation
Name (Read-only parameter) The name of the printer on the
AppleTalk network. A number after the name indicates that
there are multiple devices with this name, and this is the Nth
instance of the name.
Print Type (Read-only parameter) Specifies the AppleTalk network
printer type reported by the Jetdirect print server. Up to three
print types may be reported.
Zone (Read-only parameter) The name of the AppleTalk network
zone on which the printer is located.
Phase (Read-only parameter) AppleTalk phase 2 (P2) is
preconfigured on the HP Jetdirect print server.
Status (Read-only parameter) Indicates the current AppleTalk
configuration status.
READY: Indicates the HP Jetdirect print server is awaiting
data.
DISABLED: Indicates that AppleTalk was manually
disabled.
INITIALIZING: Indicates that the print server is registering
the node address or name. An additional status message
may also be displayed.
DLC/LLC
Command Description
dlc/llc-config Enables or disables DLC/LLC protocol operation on the print
server. 0 disables, 1 (default) enables. For example,
dlc/llc-config 0 will disable DLC/LLC operation.
strict-8022 Controls DLC/LLC protocol interpretation:
0 (default): disables, that is, provides loose interpretation.
1: enables, that is, provides strict interpretation).
Table 3.4 Telnet Commands and Parameters (12 of 13)