To do… Use the command Remarks
In system view
mirroring-group group-id
mirroring-port mirroring-port-list { both
| inbound | outbound }
interface interface-type
interface-number
[ mirroring-group group-id ]
mirroring-port { both | inbound |
outbound }
Configure
mirroring
ports for the
remote
source
mirroring
group
In interface
view
quit
Use either command
By default, no mirroring port is
configured for a mirroring group.
Configure the reflector port
for the remote source
mirroring group
mirroring-group group-id reflector-port
reflector-port
Required
By default, no reflector port is
configured for a mirroring group.
Create the remote probe
VLAN and enter VLAN view
vlan vlan-id
Required
By default, no remote probe VLAN is
configured for a mirroring group.
Assign monitor ports to the
remote probe VLAN
port interface-list
Required
By default, a newly-created VLAN
does not have any member port.
Return to system view quit —
Configure the remote probe
VLAN for the remote source
mirroring group
mirroring-group group-id
remote-probe vlan rprobe-vlan-id
Required
By default, no remote probe VLAN is
configured for a mirroring group.
NOTE:
• The reflector port of a remote source mirrorin
roup must be an access port and belon
to the defaul
VLAN, VLAN 1.
• HP recommends you confi
ure an unused port as the reflector port of a remote source mirrorin
roup
and disable STP on it.
• A mirroring group can contain multiple mirroring ports.
• To ensure that the port mirroring function works properly, do not assign a mirroring port to the remote
probe VLAN.
• A remote probe VLAN must be a static VLAN.
• To remove the VLAN configured as a remote probe VLAN, you must first remove the remote probe VLAN
with the undo mirroring-group remote-probe vlan command.
• If the remote probe VLAN of a remote mirroring group is removed, the remote mirroring group will
become invalid.
• The link type of monitor ports configured for port mirroring must be access.
137
To Next Page
Loading...
Need help?
General
