4. Remove two screws from the back of the printer (callout 3), disconnect the high-voltage wire
(callout 4) and then remove the engine-power assembly.
NOTE Be careful not to lose the two springs that are behind the engine-power assembly.
3
4
Figure 5-24 Remove the engine power assembly (2 of 2)
Reinstallation tip When reinstalling the engine-power assembly, make sure that the
cable guide is correctly installed by clipping it onto the PCB at the top, back corner and
onto the metal casing.
76 Chapter 5 Removal and replacement ENWW
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
To Next Page
Loading...
