Laser/scanner assembly
1. Remove the following assemblies.
● Right-side cover. See
Right-side cover on page 64.
●
Left-side cover. See
Left-side cover on page 66.
●
Top-cover assembly. See
Rear panel and top-cover assembly on page 66.
● Front-cover. See
Front cover on page 71.
● Engine-control unit assembly. See
Engine control unit (ECU) assembly on page 80.
2. Remove four screws (callout 1) and then remove the laser/scanner assembly.
1
Figure 5-34 Remove the laser/scanner assembly
Reinstallation tip When replacing the laser/scanner assembly, be sure to transfer the
laser shutter arm from the old assembly to the new one.
84 Chapter 5 Removal and replacement ENWW
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
To Next Page
Loading...
