Fuser (fixing) assembly
1. Remove the following assemblies.
● Right-side cover. See
Right-side cover on page 64.
●
Left-side cover. See
Left-side cover on page 66.
●
Top-cover assembly. See
Rear panel and top-cover assembly on page 66.
2. Disconnect cables, as necessary, from near the top of the engine-power assembly, and
disconnect the high-voltage wire (callout 1) from the back of the printer.
CAUTION Do not pull directly on the wires when a connector is disconnected. Always
pull on the plastic body of a connector to avoid damaging the connector wires.
1
Figure 5-25 Remove the fuser (fixing) assembly (1 of 2)
3. Remove the wire harnesses from the plastic harness retainers.
ENWW Internal assemblies 77
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
To Next Page
Loading...
