8. Disconnect one flat flexible (ribbon) cable and the connector to the step motor (callout 4).
Remove two screws (callout 5). Loosen the tape (callout 6) that secures the cable to the
chassis. As you remove the ECU, unplug the additional connector to the laser/scanner assembly.
CAUTION Do not pull directly on the wires when a connector is disconnected. Always
pull on the plastic body of a connector to avoid damaging the connector wires.
5
6
4
Figure 5-33 Remove the ECU assembly (6 of 6)
Reinstallation tip When reinstalling the ECU metal casing, make sure that the laser/
scanner shutter lever is inserted correctly through the plastic guide.
ENWW Internal assemblies 83
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
To Next Page
Loading...
