18 start guide
ENWW
Step 9. Attach power cord
1
Locate the power switch on the right
side of the printer. Make sure the
printer is turned off.
2
Connect the power cord to the
printer and a grounded power strip
or an AC outlet.
Caution
To prevent damage to the printer, use
only the power cord shipped with the
printer.
3
Turn the printer on.
4
After the printer warms up, the
READY message should appear on
the control panel display and the
Ready light should remain on. If the
READY message does not appear,
see the problem solving chapter in
the online use guide.
READY
To Next Page
Loading...