Q1860-90918 6 Removing and replacing parts 151
5 Release the tabs (callout 2) of the gear that is on the left side of the shaft, outside of the
chassis, and slide the gear off.
Figure 84. Tray 1 shaft removal (2 of 2)
6 Slide the shaft to the right, and then angle it out of the chassis.
Note Make sure that the Tray 1 lift plate (with its spring) is pressed down before you reinstall the Tray 1
shaft. The shaft holds the Tray 1 lift plate, and must be installed on top of it. Also make sure that
the shaft is reinstalled in the correct orientation.
2
2
www.GovTechMedia.com
To Next Page
Loading...
