150 Removing and replacing parts Q1860-90918
Tray 1 shaft
1 Remove the top cover (see page 115), the left and right side covers (page 123), the pickup
gear assembly (page 136), and the paper-handling PCA (page 131).
2 Remove the plastic collar on the outside, right of the chassis, by pulling outward on the
collar’s release tab and sliding the collar off of the shaft.
3 Raise the green center handle of the registration assembly.
4 Release the collar on the inside, right of the chassis by pulling up on the release tab
(callout 1), and sliding the collar to the left.
Figure 83. Tray 1 shaft removal (1 of 2, right side view of printer)
2
1
www.GovTechMedia.com
To Next Page
Loading...
