Q1860-90918 6 Removing and replacing parts 153
To reinstall
1 Tip the printer back, so that the front faces up.
2 Insert the shaft into the fitting on the right side. Then, angle the shaft into the other side.
3 Place the bushing on the right end of the shaft, and push until the tab locks in the indentation
on the shaft.
4 Facing the left side of the printer, orient the shaft so that the open end of the shaft (callout 3)
points away from the solenoid arm.
5 Depress the solenoid arm, and slide the gear into place. Press the gear into the plastic collar
until it locks in place.
6 Reinstall the spring on the arm of the gear.
Figure 86. Reinstallation of Tray 2 shaft
2
3
www.GovTechMedia.com
To Next Page
Loading...
